TRI-FLAT Easyspeed South - the innovative PV mounting system for flat roofs

Simply fast on the roof: TRI-FLAT Easyspeed gets by with just a few pre-assembled components and enables the installation of a wide range of variants on the flat roof.

TO THE TRITEC-ONLINESHOPTO THE TRITEC-ONLINESHOP

Request a project without obligationRequest project without obligation

Installation of the PV flat roof system

The PV flat roof system TRI-FLAT Easyspeed is manufactured to the highest quality standards in Central Europe and is suitable for framed PV modules. The modules are installed at an angle of approx. 10° facing south. The position is secured without penetration by means of ballast.

You already have a current project? You can sendus your project enquiryhere.

The advantages of TRI-FLAT Easyspeed South

Large support plates guarantee low point loads
Stress-free module storage due to movable adapters
No long rails, low thermal expansion and optimum water drainage
Module clamping possible on the short and long module side
Very easy to install due to pre-assembled components
Ballast optimized (aerodynamic system)
No complex surveying work
Quick and easy assembly
Ideal for warehousing & handling
Wind tunnel tested

Areas of application for TRI-FLAT Easyspeed South

TRI-FLAT Easyspeed is used on flat roofs such as foil, bitumen and gravel roofs. Roofs with a maximum building height of 25 meters and with a roof pitch of up to 5° (depending on the roof conditions without roof connection), can be built on with the system.