Photovoltaic Mounting Systems
TRITEC mounting systems bundle up more than 25 years of photovoltaic experience and know-how. Due to the realization of numerous solar systems worldwide, well thought-out solutions were conceived which offer ideal mounting solutions for any type of roof.
PV mounting systems by TRITEC enable easy and simple mounting of photovoltaic systems as on-roof and facade systems as well as roof-integrated solar systems.
Pitched roof – on-roof & facade
TRI-STAND PV mounting system: As an insertion or clip variant, it is suitable for sizes from the small stand-alone system to the major grid-connected system on all types of pitched roofs and on facades: more.
Pitched roof – trapezoidal sheet metal roof
TRI-VENT mounting system: Easiest way of mounting solar systems with minimal tool use on trapezoidal sheet metal roofs: more.
TRI-STAND on trapezoidal sheet metal: Stability on the roof – with just a few steps for swift and secure mounting: more.
Pitched roof – roof-integrated system
TRI-ROOF roof-integrated system: Roof-integrated insertion system for all module types from all manufacturers of the TRITEC PV product range: more.
Solrif: roof-integrated mounting system suitable for numerous pitched roof variants.
TRI-FLAT mounting system: Ballast- and transport-optimized mounting system for PV installations with east-west and south orientation: more.
TRI-STAND Aero PV mounting system: Aerodynamically optimized mounting system for flat roofs with low load-bearing capacity: more.
TRI-STAND East-West: Aerodynamically optimized mounting system for PV installations with east-west orientation: more.
TRI-STAND: Stable flat roof system with triangle or upright supports: more.
TRITEC guarantees top quality. With our photovoltaic mounting systems, we set great store by the high-quality processing of components and by the stability of the substructure as well.
We have independent third parties confirm the quality of our products by means of extensive tests with brand modules. We thus provide you with a warranty of reliable products for long lasting PV systems.
Mechanical stress test by TÜV
By means of the TÜV test, the mounting systems are certified within the scope of a mechanical stress test according to the international standard IEC 61215.
The test is performed in the following stages: First, a flash test determines the nominal output of the module, and the material characteristics are examined by means of an electroluminescence camera.
For the stress test, a module is fastened to the mounting system in accordance with the Instructions. Then, the module is loaded with 2400 Pa, which is equivalent to 245 kg/m2. Wind pressure or wind suction are thus simulated.
In another test run, the pressure is increased to 5400 Pa (550 kg/m2), which is equivalent to the burden due to snow pressure.
After the individual stress tests, the module is re-inspected each time – the TÜV test is only considered passed if, after the burdens, no damages to the module are detected and its performance is not impaired.
TRI-STAND, TRI-STAND Aero, TRI-ROOF and TRI-VENT have been awarded certification by TÜV Rhineland.
Wind tunnel test
Wind tunnel tests are performed for mounting systems which can be installed without roof penetrations on the flat roof.
For this, the PV system is set up as a miniature model. Based on that model, it is tested how the mounting system performs under extreme wind loads and with the ballasting specified by the manufacturer.
TRI-STAND Aero, TRI-FLAT South and TRI-FLAT East-West were successfully tested in the wind tunnel.
It’s a matter of course for us that PV mounting systems must withstand the most adverse weather conditions over a number of years. We therefore grant you a 5-year guarantee for all components of the TRITEC mounting systems.
If you participate in one of our numerous product trainings, the guarantee will be extended to a total of 10 years.